candletech.com

Handy Calculators

Calculators that may come in handy for candle makers.

Round Mold Calculator Calculate Wax Weight for a Round Mold
Use this calculator to figure out how much wax to melt to make a round candle. This calculater can also be used to estimate wax weights for other shapes such as spirals, octagons, etc.

Rectangular Mold Calculator

Calculate Wax Weight for a Rectangular Mold
Use this calculator to figure out how much wax to melt to make a rectangular candle. This can also be used for squares.

 

Calculate Wax Weight for a Container Candle
Figure out how much wax you need for containers.
Burn Time Calculator
Use this calculator to get an accurate estimate of the burn time of a candle.

» Similar Articles

  1. Water Baths
  2. How to Make Container Candles
  3. Hurricane Shells

» Comments

  1. Ann Griffin avatar

    I am just getting started, and can not find anywhere other than soy candle instructions, on how much scent to add. I am going to start out with pillar candles. Help!

    Ann Griffin — May 25, 2009 3:36 PM
  2. Mattie Sims avatar

    I am new at making candles and I cant seem to get a good scent throw. Please help.

    Mattie Sims — July 25, 2009 12:34 PM
  3. Cindy avatar

    I am trying to figure out how much wax is needed for a hurricane shell, 5 x 5.65? Please let me know if you can.

    Cindy — October 19, 2009 3:22 PM
  4. Deborah avatar

    I am not getting a good scent throw. How much do I use per pound. I use the harmony blend

    Deborah — December 16, 2009 7:12 AM
  5. jeff avatar

    how may i get a direct and easy candle formulation

    jeff — February 22, 2010 8:15 AM
  6. evon avatar

    how much vybar does one use when making candles eg. how much would you use per 100grams of wax? any advice welcome thanks

    evon — February 27, 2010 5:53 AM
  7. Sarah avatar

    Cude,could you kindly send me the formular for these calculations?asses to the internet may not be possible at all the time and thus inability to cheek the ans.

    Sarah — May 12, 2010 6:32 AM

» Leave a Comment